Open Tube copy and close the original.
In the layer palette duplicate the tube.
Click on the draw tool and start drawing a line that looks like the egg is starting to crack.
Now duplicate this layer and continue to draw the line, stop about half way and duplicate
the layer again, draw the line again leaving just a little not cracked. Duplicate and finish
drawing the line.
Duplicate again (should have a total 6 layers now)
With the lasso tool set to point to point and follow the cracked line go all the way around
the top of the egg.
Click in the middle of the matching ants to tighten and promote to layer.
Click on the deformation tool. It will go around the top part of the egg.
Swing it around and with the move tool move it to the left side touching the bottom egg corner.
Sharpen.
Like this....
This is where you can add your bunny if you like..
Duplicate the top and the bottom 4 times.
Also the bunny 4 times....
Have it where you can see his ears only.....
Then slowly move him up.
Merge each one as you get it the way you like.
Then move the top to the bottom of the egg on the back side, add bunny.
